Radiant V4400 Specifikace

RADIANT COMMUNICATIONS CORP. REV.0204 Radiant Communica

for administrative privileges to allow changes from this page. For now as a work around to no control of the DHCP setting, you can power on the unit

Appendix B: Console Menu Configuration 1. There are two ways to connect to the Console Menu System in the V4410. a) If the IP address of the V4410

Select a name and an icon for this connection…then hit OK Choose the appropriate communications port, the one the cable is connected to…then hit OK

Configure the settings so the match the above…then hit OK. 13

2. Once connected to the console Menu System, either by telnet or by a serial connection the interaction should be same in either case. In order to

Appendix C: Special PC Configuration 1. If all other communication fails with the unit, due to interoperable network configurations it may be necess

7. Record the current settings in this window, because we are going to want set them all back to how they look now when we are done. If it is curre

the other end into the V4410 unit, and then power up the unit. 11. Assuming that you PC is not running any kind of a DHCP server itself, the Encoder s

V4420 Decoder Set-up and Installation All set-up interactions with the V4420 will be handled via the IR Keyboard provided. Management pages Internal

Use proxy Accept cookies Disk cache (Kbytes) 0 Ram Cache (Kbytes 300 The Ram Cache size is a compromise between the memory required to handle ve

2 DESCRIPTION ...

SPECIFICATIONS INPUTS/OUTPUTS VIDEO NTSC 1Vp-p, 75 ohm, 60Hz Or PAL 1Vp-p, 75 ohm, 50Hz AUDIO 2 channels (stereo), line level NETWORK Data Rate: 1-

NOTES 21

3 DESCRIPTION The Radiant Communications Corp. V4400 Series Provides broadcast quality, full motion video over IP networks. The system

4 V4410 Set-up Hardware Installation 1. Connect the video source to either the BNC Video connector (for composite video) or the S-Video connec

b. Select a name and an icon for this connection, click OK. c. Specify the port that you are connected to on your PC (typically COM1), click OK. d.

e. From the Main Admin Menu, select “5” and press ENTER to open the Config Menu. f. Once DHCP is turned off, you will want to modify options 4–7. Rec

g. When you are finished configuring options, select “12” to Save your settings, and “99” to Return to the Main Admin Menu. 7

4. Before exiting HyperTerminal, you can assign an Administrative Username and Password to the V4410. a. From the Main Admin Menu, select “5” Config M

Appendix A: Embedded Web Server Configuration 1. To configure a V4410 unit via the embedded web sever, you must first determine the current IP addr